Anyone who has been in contact with medical x-ray 
knows that three tinned copper terminals are cast on the bottom of the x-ray high-voltage cable socket. Drill a 1cm deep hole in the middle of the terminal, so the plug and socket for the x-ray high voltage cable fit perfectly. The plug front end of the X-ray high voltage cable is equipped with three copper pins connected to the socket. There are wiring holes on the pins of the welding cable core wires. The copper horn is inserted into the inner end of the plug and is soldered with the metal shield of the cable to form a good ground. X-ray high-voltage cable plug: Its pins are die-cast on the side of the high-voltage plug, and the root of the pin is provided with a small lead hole for passing through the conductive core wire and soldering the conductor core wire to the root of the pin. In order to match the high-voltage plug, the bottom of the high-voltage cable socket will provide three copper terminals that match the high-voltage plug, and each terminal has a round hole for inserting the power plug into the high-voltage plug. In order to improve the insulation strength of the x-ray high-voltage cable, the gap between the high-voltage cable and the high-voltage plug must be filled with insulating oil such as high-voltage silicone grease or rosin. The bottom of the high-voltage cable plug is also equipped with a metal bell mouth, the purpose of which is to improve the distribution of the electric field generated by the ground and prevent the wiring between it and the ground from being too dense. Share these today.
If you have problems with medical x-ray 75/90kv high-voltage cables such as oil leakage, ignition, breakdown, etc., which need to be repaired and replaced with new cables, please call for consultation and business negotiation. Tel (whatsapp): +8617616362243!
Post time: Feb-07-2023