What are the manufacturers of medical chest bucky stand? Let me introduce to you the bucky stand produced by Newheek.
Place the bucky stand on a flat hard surface 180cm away from the tube, so that the vertical center of the filming box coincides with the center of the tube. Install four M8 expansion screws with an electric hammer, and then tighten them; after the adjustment is correct, you can shoot at this time.
Use of the photo frame
(1) Hold the handle of the film carriage, pull out the film carriage in the film box, snap the selected film box (or IP board, DR detector) into the moving film clip, and push down the moving film clip to make the film box ( Or IP board, DR detector) placed in the upper and lower film clips, and clamped;
(2) Push the film carriage into the box and clamp it tightly;
(3) Loosen the locking handle, adjust the height of the trolley frame according to the filming position, and reach the suitable height of the filming box. After adjustment, lock the handle to take the film.
(4) After the filming is completed, pull out the film carriage, take out the film cassette (or IP board, DR detector) from the film holder; and push the film carriage into the filming case.
If you have purchasing needs for the bucky stand, welcome to contact us, phone (whatsapp): +8617616362243!
Post time: Sep-21-2022